Speaker Dynamic Control - LD Systems LDDSP44K Bedienungsanleitung

SPEAKER DYNAMIC CONTROL

9.38
9.41 9.44
9.39
9.45
9.42
9.41 9.44
9.38
9.40
9.46
9.43
SPEAKER RMS DYNAMIC CONTROL
9.38 LIMIT - Click on the arrow icon to adjust the limiter to the RMS capacity of the speaker.
Virtual Fader - Click and hold the Virtual Fader button and move it upwards or downwards to adjust the limiter to the RMS capacity
9.39
of the speaker.
Display / Input Field - Displays the limitation in watts RMS and allows direct input via keyboard.
9.40
RATIO - Click on the arrow icon to configure the control ratio when using as a compressor.
9.41
9.42 Virtual Fader - Click and hold the Virtual Fader button and move it upwards or downwards to set the control ratio when using as a
compressor.
9.43 Display / Input Field - Displays the control ratio and allows direct input via keyboard.
KNEE - Click on the arrow icon to adjust the characteristic curve to the height of the threshold value (in this case, W RMS)
9.44
(low value = hard transition between raw and processed signal, high value = soft transition between raw and processed signal).
Virtual Fader - Click and hold the Virtual Fader button and move it upwards or downwards to adjust the characteristic
9.45
curve to the height of the threshold value (in this case, W RMS).
Display / Input Field - Displays the value and allows direct input via keyboard.
9.46
9.47 RMS DETECTOR
BYPASS - RMS DYNAMIC CONTROL disabled (click button).
COMPRESSOR - Use as compressor (click button).
LIMITER - Use as limiter (click button).
Auto TC - Check box to automatically set Attack, Hold Time, and Release.
9.48
9.49 ATTACK - Allows manual configuration of the response time via the arrow icons and direct input via keyboard (uncheck box for Auto TC).
HOLD TIME - Allows manual configuration of the hold time via the arrow icons and direct input via keyboard (uncheck box for Auto TC).
9.50
9.51 RELEASE - Allows manual configuration of the release time via the arrow icons and direct input via keyboard (uncheck box for Auto TC).
SPEAKER PEAK DYNAMIC CONTROL
9.52 LIMIT - Click on the arrow icon to adjust the limiter to the peak capacity of the speaker.
Virtual Fader - Click and hold the Virtual Fader button and move it upwards or downwards to adjust the limiter to the
9.53
peak capacity of the speaker.
Display / Input Field - Displays the limitation in watts PEAK and allows direct input via keyboard.
9.54
9.55 Auto TC - Check box to automatically set Attack and Release.
ATTACK - Allows manual configuration of the response time via the arrow icons and direct input via keyboard (uncheck for Auto TC).
9.56
9.57 RELEASE - Allows manual configuration of the release time via the arrow icons and direct input via keyboard (uncheck box for Auto TC).
KNEE
9.58 - Click on the arrow icon to adjust the characteristic curve to the height of the threshold value (in this case, W PEAK)
(low value = hard transition between raw and processed signal, high value = soft transition between raw and processed signal).
Virtual Fader - Click and hold the Virtual Fader button and move it upwards or downwards to adjust the characteristic
9.59
curve to the height of the threshold value (in this case, W RMS).
9.47
9.52
9.53
9.48
9.49
9.50
9.51
9.52
9.54
9.66
9.61
9.55
9.58
9.56
9.57
9.59
9.64
9.58
9.60
9.63
9.62
9.65
15