Optional Accessories - HUPFER TE-2/V19-26 Betriebsanleitung

Chapter 3
Page 14
3.4.3 Appliance description
The plate dispensers accommodate clean chinaware and plates made of toughened glass in a adjustable,
spring-loaded guide basket. Owing to the use of special springs, crockery items are moved automatically and
constantly over the entire lift upwards to a uniform dispensing height.
If necessary, there are various models available. A plate dispenser model 19-26 is particularly suitable for
plates with diameter of 7.48'' to 10.24''. A plate dispenser model 27-33 is particularly suitable for plates with
diameter of 10.63'' to 13''.
All the plate dispensers are universally adjustable appliances suitable for the plate diameters, stack heights
and weights given above. The ergonomically favourable dispensing height can be adjusted within a limit to
persons of different height. Plate dispensers are available as one-tube and two-tube models.
Unheated appliances with enclosed side and front walls store crockery at normal temperature ready for use.
Unheated appliances with cooling slots are particularly suitable to be used in cold stores. When used in the
cold store, the cooling slots arranged on the side and front walls of the appliance housing ensure a rapid ex-
change of air and cause the cold air to be distributed uniformly inside.
The appliances with electric heating (static or circulating air) pre-warm the plates or heat them up to a pre-
set temperature.
Besides the mobile plate dispensers, there are built-in plate dispensers intended for installation in worktops.
Depending on the purpose, the built-in appliances are available in different sizes, as one and two-tube mod-
els and heated or unheated.
The operating temperature can be continuously set on the heated plate dispensers. The controller is ar-
ranged on the front of the housing and can be adjusted as required when using built-in appliances.
The covers made of plastic protect the crockery against dust and condensed water even during relatively
long periods of temporary storage. Using a cover in the heated appliances lowers the heat loss upwards and
reduces the heating time of the inserted crockery or delays the cooling of pre-warmed crockery. The cover is
included in the scope of delivery of the heated models.
3.4.4

Optional accessories

The following parts can be applied as optional accessories for the plate dispenser:
§
Cover Ø 7.48''-10.24'' high for plate dispenser model 19-26
§
Cover Ø 7.48''-10.24'' flat for TEUH-2/VC 19-26 (not suitable for other models)
§
Cover Ø 10.63''-13'' for plate dispenser model 27-33
§
Swivel casters made of stainless steel, Ø 4.92'' with and without brakes, plate attachment
The part numbers of the special accessories can be found in the spare parts catalogue and order lists avail-
able online.
Plate dispenser
TE-2/V19-26, 27-33 | TE-2/VK19-26 | TEH-1/V19-26, 27-33 | TEH-2/V19-26, 27-33 | TEUH-1/VS19-26 | TEUH-2/VS19-26, 27-33 | TEUH-2/VC19-26
EBR/V19-26, 27-33 | EBRH/V19-26, 27-33 | EBRH-2/V19-26
Description and Technical Data
Appliance Description
4330000_A6