Safety Instructions For Cleaning And Care; Safety Instructions For Troubleshooting; Notes On Specific Hazards - HUPFER TE-2/V19-26 Betriebsanleitung

Safety Instructions

Safety Instructions for Cleaning and Care

§
Do not use any extension leads in wet and damp areas.
§
Only insert mains plugs into suitable sockets. If the mains plug does not fit, the lead of the appliance
is to be retrofitted by authorised specialist staff.
§
The use of socket adapters is not permitted. Risk of fire.
§
Do not clean the appliance with steam-jet or high-pressure washers. The appliance must be taken out
of operation and switched off at the mains beforehand in any area where steam-jet or high-pressure
washers are to be used.
2.4 Safety Instructions for Cleaning and Care
The following points must be observed when carrying out any cleaning and maintenance operations:
§
For reasons of hygiene the cleaning instructions must be strictly observed.
§
Take the appliance out of operation before starting the cleaning process. Pull out the mains plug and
insert it into the holder located on the appliance.
§
For cleaning, the appliance must be out of operation and cooled down sufficiently.
§
Do not clean the appliance with steam-jet or high-pressure washers. The appliance must be taken out
of operation and switched off at the mains beforehand in any area where steam-jet or high-pressure
washers are to be used.
§
Even appliances without an electrical connection should not be cleaned with running water or pres-
surised water.
2.5

Safety Instructions for Troubleshooting

The following points shall be observed when carrying out any maintenance and troubleshooting operations:
§
All troubleshooting work should only be carried out by authorised specialists.
§
When carrying out troubleshooting work, it must be ensured that the appliance is switched off. When
working on the electrical installation, the appliance must be switched off at the mains and secured
against reactivation.
§
The local applicable Accident Prevention Regulations must be observed.
§
Defective components should only be replaced with original parts.
2.6

Notes on Specific Hazards

Electrical energy
§
All work on the electrical installations should only be carried out by a certified electrician or by author-
ised specialists under supervision and monitoring of a certified electrician according to the applicable
electro-technical regulations.
§
The appliances on which inspection, maintenance and troubleshooting work is performed must be
disconnected from the power supply and secured against reactivation when the voltage is not re-
quired for this kind of work. This must only be carried out by a certified electrician.
4330000_A6 TE-2/V19-26, 27-33 | TE-2/VK19-26 | TEH-1/V19-26, 27-33 | TEH-2/V19-26, 27-33 | TEUH-1/VS19-26 | TEUH-2/VS19-26, 27-33 | TEUH-2/VC19-26
EBR/V19-26, 27-33 | EBRH/V19-26, 27-33 | EBRH-2/V19-26
Chapter 2
Page 11
Plate dispenser