Herunterladen Inhalt Inhalt Diese Seite drucken

Cameo ZENIT B200 Bedienungsanleitung Seite 12

Vorschau ausblenden Andere Handbücher für ZENIT B200:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20
Settings
Runtime
=
Wireless Setting
=
Display Reverse
=
Display Backlight
=
DMX Fail
=
AC Failure
=
Dimmer Curve
=
Dimmer Response
=
12
Increase battery life by up to
24 hours with correspond-
ingly reduced brightness
(calculated on full with 100%
battery)
W-DMX settings (Wire-
less-DMX)
Flip display
Display lighting
Operating status with DMX
signal fault
Operating status in the event
of a power failure
dimmer curve
dimmer sensitivity
Off
Function deactivated
4 hours - 24 hours
Configure battery run time from 4 hours to 24
hours in 1 hour increments.
W-DMX On/Off
On = W-DMX enabled
Off = W-DMX disabled
Operating Mode
Receive = W-DMX module as receiver
Receive = W-DMX module as sender
Transmitting Mode
G3 = G3 broadcasting standard
G4S = G4S broadcasting standard
Link
Link = pair with W-DMX units. W-DMX must be
enabled on all devices, and the pairing with a
transmitter be retained (Receive Reset).
Unlink = decoupling of all devices
Receive Reset
No = Do not retain transmitter pairing
Yes = Retain transmitter pairing
On
Rotate display by 180° (e.g. for overhead
installation)
Off
No display rotation
On
On permanently
Off
Deactivation after approximately 1 minute of
inactivity
Hold
Last command is retained
Blackout
Activates blackout
Full On
All the LEDs have 100% output
Stand Alone
Spotlight switches to the last selected stand-
alone mode
No Action
Last command is retained
Blackout
Activates blackout
Full On
All the LEDs have 100% output
Stand Alone
Spotlight switches to the last selected stand-
alone mode
Linear
Light intensity increases linearly with DMX value
Exponential
Light intensity can be finely adjusted at lower
DMX values and broadly adjusted at higher DMX
values
Logarithmic
Light intensity can be broadly adjusted at lower
DMX values and finely adjusted at higher DMX
values
S-Curve
Light intensity can be finely adjusted at lower
and higher DMX values and broadly adjusted at
medium DMX values
LED
Lamp responds abruptly to changes in DMX value
Halogen
Lamp behaves like a halogen spotlight with soft
brightness changes

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Clzb200

Inhaltsverzeichnis