Cameo ZENIT B200 Bedienungsanleitung Seite 11

COLOUR TEMPERATURE (Tunable White)
The colour temperature mode enables you to configure the colour temperature from cold white to warm white (CTC) and the brightness (Dim) of the
light directly on the device. Select the colour temperature mode as per the procedure previously described in SETTING STAND ALONE MODE and
confirm with ENTER. Using the UP and DOWN controls, now select the menu item that you wish to edit (observe arrow) and confirm with ENTER.
The display will show a three-digit number field and you can use the UP and DOWN controls to configure the desired value. Confirm with ENTER.
Press MODE three times to return to the main display (Mode Tunable White).
----------- Stand Alone -----------
Auto
Colour Macro
Static
Tunable White
User Colour
USER PRESETS (User colour)
The operating mode "User Presets" allows you to store five individual colour presets of overall brightness, strobe and a colour mix of R, G, B and W
directly in the device. Select the "User Colour" mode as per the procedure previously described in SETTING STAND ALONE MODE and confirm with
ENTER. Use UP AND DOWN to select one of the stored presets Color1 to Color5 and confirm with ENTER and select the submenu item you want to
edit (see arrows). Confirm with ENTER.
The display will show a three-digit number field and you can use the UP and DOWN controls to set the value as required between 000 and 255.
Confirm by pressing ENTER again. When all settings are configured as required, press MODE 4 times to return to the main display (Mode User
Colour).
----------- Stand Alone -----------
Auto
Colour Macro
Static
Tunable White
User Colour
SLAVE MODE CONFIGURATION
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "Slave" (observe arrow) and confirm
with ENTER. Connect the slave and the master units (same model) with a DMX cable and enable one of the standalone modes on the master
unit (Auto, Colour Macro, Static, Tunable White, User Colour). Now the slave unit will follow the master unit. If there is no control signal, the
display characters will flash. Flashing stops as soon as a control signal is present.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
DEVICE SETTINGS (Settings)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "Settings" (observe arrow) and confirm
with ENTER.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the following submenu items (selection with UP and DOWN, confirm with ENTER):
---------- Programme x ----------
Dim <100>
CTC <255>
Dim CTC
000 000
– –
100 255
------------ User Colour ------------
Color1
Color2
Color3
Color4
Color5
Mode
Slave
Mode
Tunable White
------------ Colour1 ------------ 001
Dimmer <255>
Strobe <255>
Red <255> 255
Green <255>
Blue <255>
White <255>
–
Mode
User Colour
11