Abicor Binzel iCAT mini ABIROB G Serie Betriebsanleitung Seite 47

iCAT mini
Fault
Welding wire is not
correctly fed
Tab. 11 Troubleshooting
11 Disassembly
BAL.0361.0 • 2017-05-05
Cause
• Wire conduit coil is soiled
• Wire conduit coil worn
• Wire conduit coil cut to short
• Wire guide soiled by wire wear
(model with wire brake)
D
DANGER
Risk of injury due to unexpected start
The following instructions must be followed during all maintenance,
servicing, disassembly and repair work:
• Switch off the power source.
• Close off the gas supply.
• Close the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and
damage.
• Replace any damaged, deformed or worn parts.
11 Disassembly
Troubleshooting
• Disassemble wire conduit coil
and air-blast with compressed air
• Wear safety goggles
 9 Maintenance and cleaning
on page EN-19
• Replace wire conduit coil
• Mount new wire conduit coil
• Disassemble wire guide and air-
blast with compressed air.
• Wear safety goggles
 9 Maintenance and cleaning
on page EN-19
EN - 23