Dry Applications; Maintenance And Repairs - Nilfisk-ALTO ATTIX 200 Series Betriebsanleitung

ATTIX 200

Dry applications

Note
1. The supplied filters and the safety container (if applicable)
must be installed correctly.
DANGER !
Comply with the safety regulations governing the materials
for which the vacuum cleaner is used.
Use as a dust extractor only
(M and H classes only)
WARNING!
The vacuum cleaner , only in M and H versions, can be
used as a "dust extractor" in compliance with EN60335-2-
69: 2003-08 – par AA.22.202. These versions are equipped
with a horn that warns the user when the vacuum speed
drops under 20 m/s.
The horn is set to work properly when the vacuum cleaner
is connected to a 3-meter-long hose with a nominal
diameter that comply with the indications in the technical
data table (page 7). For different configurations, please
contact the manufacturer's Service Centre.
WARNING!
When the vacuum cleaner is used as a dust extractor, it
must be used in well-ventilated areas, to provide proper air
change in the room where the exhaust air will be delivered.
Always refer the Laws in the country of use.
I
GB
F
D
E
C329

Maintenance and repairs

DANGER !
Disconnect the vacuum cleaner from its power source
before cleaning, servicing, replacing parts or converting
it to obtain another version/variant; the plug must be
removed from the socket.
– Carry out only the maintenance operations described
in this manual.
– Use only original spare parts.
– Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could jeopardize
your safety. Moreover, such action would immediately void
the EC declaration of conformity issued with the vacuum
cleaner.
DANGER !
To carry out maintenance operations which are not
described in this manual contact the manufacturer's
Service Centre or our sales network.
6
11/2008