Technical Data; Noise And Vibration Information - MIRKA DEOS Bedienungsanleitung

en

Technical data

Mirka® DEOS
Power
Mains voltage
Speed
Orbit
Size of backing pad
Weight
Degree of protection

Noise and vibration information

Measured values are determined according to EN 60745
Mirka® DEOS
Sound pressure level (L
Sound power level (L
Sound measurement uncertainty K
Vibration emission value a
Vibration emission uncertainty K *
Specifications subject to change without prior notice Model range may vary between markets
* The values stated in the table are derived from laboratory testing in conformity with stated codes and standards and
are not sufficient for risk evaluation Values measured in a particular work place may be higher than the declared
values The actual exposure values and amount of risk or harm experienced by an individual are unique to each
situation and depend upon the surrounding environment, the way in which the individual works, the particular
material being worked, work station design and the user's exposure time and physical condition KWH Mirka Ltd
accepts no responsibility for the consequences of using declared values instead of actual exposure values for any
individual risk assessment
Further occupational health and safety information can be obtained from the following websites:
https://osha europa eu/en (Europe) or http://www osha gov (USA)
Proper use of tool
This sander is designed for sanding all types of materials, i e metals, wood, stone, plastics, etc using abrasives designed
for this purpose Do not use this sander for any other purpose than that specified without consulting the manufacturer
or the manufacturer's authorized supplier Only use original Mirka backing pads that are designed for optimal
performance Other backing pads may reduce performance and will increase vibration The cooling air vents on the
housing must be kept clean and free of blockages to ensure air circulation Repair work may only be carried out by an
authorized service center
Work stations
The tool is intended to be operated as a hand-held tool It is always recommended that the tool should be used when
standing on a solid floor It can be used in any position but before any such use, the operator must be in a secure
position, have a firm grip and footing, and be aware that the sander can develop a torque reaction See the section
"Operating Instructions"
46
Mirka® DEOS 353 & 383 • 81 x 133 mm (3 x 5") & 70 x 198 mm (3 x 8")
)
pA
)
WA
*
h
383CV
250 W
220–240 VAC
5 000–10 000 rpm
3,0 mm (1/8")
70 x 198 mm (3 x 8")
1,0 kg (2,2 lbs)
I
383CV
71 dB(A)
82 dB(A)
3,0 dB
2,6 m/s
2
1,5 m/s
2
353CV
250 W
220–240 VAC
5 000–10 000 rpm
3,0 mm (1/8")
81 x 133 mm (3 x 5")
0,97 kg (2,1 lbs)
I
353CV
69 dB(A)
80 dB(A)
3,0 dB
2,6 m/s
2
1,5 m/s
2