Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Instructions; Unpacking - IKA Roller 6 basic Betriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

  • DEUTSCH, seite 3
For your protection
Read the operating instructions in full before
starting up and follow the safety instruc-
tions.
Keep the operating instructions in a place where they can
be accessed by everyone.
Ensure that only trained staff work with the appliance.
Follow the safety instructions, guidelines, occupational
health and safety and accident prevention regulations.
Wear your personal protective equipment in accordance
with the hazard category of the medium to be processed.
Otherwise there is a risk of:
- splashing liquids
- projectile parts
- body parts, hair, clothing and jewellery getting caught.
Set up the device in a spacious area on an even, stable,
clean, non-slip, dry and fireproof surface.
The feet of the appliance must be clean and undamaged.
Check the appliance and accessories beforehand for dama-
ge each time you use them. Do not use damaged compo-
nents.
Caution!
There is a crush hazard between the moving
parts and the casing.
Place the test tubes safely between the rollers.
Ensure accessory parts are secured carefully as test tubes
can be damaged or ejected otherwise.
Always load the samples evenly on the device.
The weight of the load must not exceed 2 kg. Do not ex-
ceed the maximum permissible shaking weights.
Do not move or transport the device when it is operating or
connected to the power supply.
Reduce the speed if
- medium sprays out of test tube due to excessive speed,
- the appliance is not running smoothly,
- dynamic forces start to cause the device and/or test tubes
to move around.

Unpacking

Please unpack the device carefully.
In the case of any damage a detailed report must be sent immediately (post, rail or forwarder).
Delivery scope
IKA
®
Roller 6/10 basic/digital, depending on the type that was ordered
AC adapter, see Fig. 1
Plate SH
Operating instructions
Warranty card

Safety instructions

The appliance is not suitable for manual operation.
Beware of the risk of
- flammable materials
- glass breakage as a result of mechanical shaking power
The appliance may heat up when in use.
Only process media that will not react dangerously to the
extra energy produced through processing. This also applies
to any extra energy produced in other ways, e.g. through
light irradiation.
Process pathogenic materials only in closed vessels under
a suitable extractor hood. Please contact IKA
any questions.
Do not operate the appliance in explosive atmospheres,
with hazardous substances or under water.
Safe operation is only guaranteed with the accessories de-
scribed in the "Accessories" chapter.
Always disconnect the plug before fitting accessories.
Disconnect the device from the power supply before you
open the cover or adjust the inclination angle of the device
shaking table.
Do not operate the device with the cover open.
The appliance can only be disconnected from the mains
supply by pulling out the mains plug or the connector plug.
The socket for the mains cord must be easily accessible.
The IKA
when power is restored after a power outage. If the IKA
Roller 6/10 digital is running in mode A it does not restart
automatically when power is restored after a power outage.
For protection of the equipment
The appliance may only be opened by experts.
The voltage stated on the type plate must correspond to the
mains voltage.
Removable parts must be refitted to the appliance to pre-
vent the infiltration of foreign objects, liquids etc.
Protect the appliance and accessories from bumps and im-
pacts.
The device must only be operated with the original plug-in
power supply unit.
Unpacking
®
Roller 6/10 basic does not restart automatically
®
if you have
®
Fig. 1
11

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis