Abus RM40Li Bedienungs-, Installations- Und Wartungsanleitung Seite 29

For installation and attachment, see diagram ➌
1. Loosen the wireless smoke detector from the base of the housing by turning it
anticlockwise. Mark the drill holes through the base.
2. Drill the holes, put in the plugs and screw in the base.
3. Insert the battery (see diagram ➊) and fasten the wireless smoke detector by
twisting it clockwise onto the base. The detector has a safety device that prevents
installation without a battery.
4. If you cannot fasten the wireless smoke detector to the base: Check whether the
battery is correctly inserted and connected.
Operation and function test
• The wireless smoke detector is ready for use as soon as you put in the battery.
• The smoke detector can be used alone or with other RM40 Li detectors connected
wirelessly, offering a greater level of safety.
• Under the housing cover there is an indicator lamp which flashes every 30 seconds
to show that the battery is correctly inserted and is delivering enough power to
generate an alarm.
• Check the function of the smoke detector at regular intervals. Press the test button
(the lower section of the housing cover) for approx. 1 second. If you hear a signal,
the device is working properly and can be fastened. The test signal (3 beeps)
sounds 4 times in total and the integrated LED flashes too.
MoAnLtg_RM40Li_2015.indd 29
Warning
• When marking out the drill holes, make sure there are no electrical wires
or cables, pipes or other important components behind them.
• If in doubt, consult an expert before drilling.
• If you are fitting the wireless smoke detector in a vehicle (such as a
camper or caravan), you must contact the manufacturer or your local
dealer first for information on the most suitable location.
– 29 –
Putting into operation
GB
21.01.15 15:57