Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Translation of the original instructions
1
Dent pulling work using the inertia ham-
mer,sparks or hollow pulling clamp.
2 Crimped welding wire or rings for straightening
works.
3 Impacts beating with an specific copper nozzle.
- To change the power level, press on the arrows (6). The power levels available allow the straightening of
sheets of varying thickness.
Power level
Metal sheet thickness
(mm)
- To change the point time, press on the narrow (7). - (Accessible in MANUAL mode only).
Points time (ms)
6. By using the button (13), select the type of ignition (cf. ignition part) :
- the indicator 11 (
- the indicator 12 (
7. Follow the instructions to perform the welding point(s).
8. After the first use, the GYSPOT EXPERT will light up each time the machine starts on the previous settings. It also
records the setting of the last weld point made for each tool and gun.
USE INSTRUCTIONS (III P.6)
Operation
Follow the process:
1. Connect the earth clamp of the generator to the sheet metal to be straightened and follow the instructions below:
• Connect it as close as possible to the place to be welded.
• Do not connect it to a different part of the car body (example: Do not connect it on the door when working on the
wing).
• Ensure the metal has been properly stripped at the connection point.
2. Strip clean the area where the work is to be performed.
3. Attach the required tool to the end of the gun, tightening the nut firmly.
4. Select the tool and the power (cf. startup part).
5. Create contact between the gun tool and the metal (cf. ignition part).
6. Perform your welding spot.
Ignition
The GYSPOT EXPERT 200 / 400 is supplied with 2 ignition systems:
Manual mode (using the trigger)
1. Plug the power connector and the command connector connected,
2. Press the ignition select button (13) until to turn the LED on (11-
The automatic mode does not work anymore, only one pressure on the trigger allows the welding point.
Automatic mode
1. Plug the power connector,
2. Press the ignition select button (13) until to turn the LED on (12 -
GYSPOT EXPERT 200 / 400
L
1
2
0,6
0,7
0,8
L
1
2
10
20
30
) indicate the use of a trigger gun.
) indicates the use of an automatic trigger.
4 Carbon shrinking electrode.
5 Welding rivets for side rods.
6 Welding rings to connect the earth.
7 Welding studs to connect the earth connection
cables
3
4
5
6
0,9
1,0
1,1
1,2
3
4
5
6
40
50
80
100
).
).
EN
7
8
9
H
1,3
1,4
1,5
1,6
7
8
9
H
200
300
400
500
15
Werbung
Inhaltsverzeichnis
