9.2 Programming With Märklin-Central Unit 6020/6021 - D&H DH05C Anleitung

9.2 Programming with Märklin-central unit 6020/6021
1 Short programming allows entering figures between 0 and 79, i.e. in short mode just setup parameter
< 80 can be changed, if the desired value should also be < 80.
2 Long programming allows entering figures between 0 and 255, i.e. in long mode all setup parameters
with values from 0 to 255 can be changed. As the display of 6020/6021 allows only binary values, the
inserting values have to be divided and entered in two steps.
3 Programming SUSI parameter.
Please notice, that 6021/6020 allows only entering values from 01 to 80. Value 0 is missing. Instead of '0'
always '80' must be entered.
Changing in programming mode
The driving controller must display 0. There may not be other locomotives on the layout.

Notice the flashing signal of the locomotive!
 Push STOP- and GO-button of 6021 simultaneously until reset will be triggered (alternatively: discon-
nect for a moment the short plug of the transformer). Push STOP-button for disconnecting the track
power.
Enter the current decoder address. If you do not know the address, enter '80'.

 Revert the driving direction with the driving controller (turn the driving controller to the left beyond the
keystroke until you hear a click), hold the controller and push GO-button.
 After about 1 second the lights of the engine are flashing, the decoder is now in programming mode.
27