Care And Cleaning - Electrolux TK 5357 F Benutzerinformation

58 electrolux
To change or set a new programme, you
must deactivate the child lock function.
Starting the programme
Push the Start/Pause button. The approximate cy-
cle time visible on the display starts to elapse.
Changing programme
To change a programme which has been selected
by mistake once the programme has started, first
turn the programme selector to Off (Aus) and then
reset the programme.
The programme can no longer be changed
directly once the programme has started. If
nevertheless there is an attempt to change the
programme on the programme knob, the pro-
gramme progress display and the maintenance in-
dicators flash. If an option (excluding the buzzer )
is set, Err appears in the multidisplay. The drying
programme is not however affected by this (laun-
dry protection).
Cycle end / laundry unloading
Important! After each drying cycle:
• clean the fluff filters
• drain the condensed water container

Care and cleaning

Cleaning fluff filter
The filters collect all the fluff which accumulates
during drying. To ensure that the dryer works per-
fectly, the fluff filters (micro-fine filter and fine strain-
er) must be cleaned after every drying cycle.
The Filters (Sieb) diode is on to remind you of this
operation.
Caution! Never operate the dryer without
fluff filters or with damaged or blocked fluff
filters.
1.
Open loading door
2. Use a damp hand to clean the micro- fine filter,
which is built into the lower part of the loading
aperture.
•
(see " Care and cleaning " chapter.)
Once the drying cycle is complete, display shows
a blinking . If the Buzzer (Signal) button has been
pressed, an acoustic signal sounds intermittently
for about one minute.
The drying cycles are automatically followed
by an anti-crease phase which lasts around
30 minutes. The drum rotates at intervals during
this phase. This keeps the laundry loose and free
of creases. The laundry can be removed at any
time during the anti-crease phase. (The laundry
should be taken out towards the end of the anti-
crease phase at the latest to prevent creases from
forming.) If long anti-crease function has been se-
lected, the anti-crease phase is lengthened by 60
minutes.
1. Open door.
2. Remove fluff from the fluff filters (see " Care and
cleaning " chapter.)
3. Remove laundry.
4. Turn the programme selector to Off (Aus) po-
sition.
5. Close the door.
3.
After a period of time, a patina due to deter-
gent residue on laundry forms on the filters.
When this occurs, clean the filters with warm
water using a brush. Remove the filter from the
door pulling it out. It can be positioned with the
tooth facing to the left or to the right).
After cleaning do not forget to put it back.