Electrolux TK 5357 F Benutzerinformation Seite 52

52 electrolux
Installation
Appliance positioning
• It is recommended that, for your convenience,
the machine is positioned close to your washing
machine.
• The tumble dryer must be installed in a clean
place, where dirt does not build up.
• Air must be able to circulate freely all round the
appliance. Do not obstruct the front ventilation
grille or the air intake grilles at the back of the
machine.
• To keep vibration and noise to a minimum when
the dryer is in use, it should be placed on a firm,
level surface.
• Once in its permanent operating position, check
that the dryer is absolutely level with the aid of a
spirit level. If it is not, raise or lower the feet until
it is.
• The feet must never be removed. Do not restrict
the floor clearance through deeppile carpets,
strips of wood or similar. This might cause heat
built-up which would interfere with the operation
of the appliance.
Important!
• The hot air emitted by the tumble dryer can
reach temperatures of up to 60°C. The appli-
ance must therefore not be installed on floors
which are not resistant to high temperatures.
• When operating the tumble dryer, the room tem-
perature must not be lower than +5°C and high-
er than +35°C, as it may affect the performance
of the appliance.
• Should the appliance be moved, it must be
transported vertically.
• The appliance must not be installed behind the
lockable door, a sliding door a door with a hinge
on the opposite side to that of the appliance in
such a way that a full opening of the dryer is re-
stricted.
Removing transport safety packaging
Caution!
Before use all parts of the transport packaging
must be removed.
1. Open loading door
2. Pull off adhesive strips from inside machine on
top of drum.
3. Remove foil hose and polystyrene padding
from the machine.
Electrical connection
Details on mains voltage, type of current and the
fuses required should be taken from the type plate.
The type plate is fitted near the loading aperture
(see "Product description" chapter).
Connect the machine to an earthed socket, in
accordance with current wiring regulations.
Warning! The manufacturer declines
any responsibility for damage or injury
through failure to comply with the above
safety precautions.
Should the appliance power supply cable
need to be replaced, this must be carried out
by our Service Center.
Warning! The plug must be accessible
after installing the machine.
Door reversal
Warning! Before changing the door stop,
disconnect the mains plug.
1.
A
A
Open loading door.
2. Unscrew hinge A from the front of the machine
and take off the loading door.
3. Remove cover plates B . To do this, insert a
thin screwdriver into the slots as shown in the
illustration, press downwards slightly and pry
out the cover plates.
4. Use an appropriate tool and exert pressure to
unfasten locking block C from the snap-on fix-
ture, take out and re-insert on the other side
having rotated the block through 180°.
5. Unscrew hinge A from the loading door, rotate
through 180°, re-insert on the opposite side
and screw down.
6. Re-insert cover plates B on the opposite site
having first rotated them through 180°.
7.
D
E
E
D
B
C
B
1
F F