TFA 35.1026.54.IT Bedienungsanleitung Seite 35


When the batteries of the transmitter are used up, the low battery icon appears near the outdoor
temperature display.
Note:
In the event of changing batteries in any of the units, all units need to be reset by following the setting up
procedures. This is due to a random security code assigned by the transmitter at start-up. This code must be
received and stored by the weather station in the first 3 minutes of power being supplied to the transmitter.
SETTING UP:
WHEN ONE TRANSMITTER IS USED
First, insert the batteries in the transmitter (see "How to install and replace batteries in the
1.
temperature transmitter" above).
2. Within 2 minutes of powering up the transmitter, insert the batteries in the weather station (see
"How to install and replace batteries in the weather station" above). Once the batteries are
in place, all segments of the LCD will light up briefly. Following the indoor
temperature/humidity and the time as 0:00 will be displayed. If this information is not displayed
on the LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before
reinserting them. Once the indoor data is displayed user may proceed to the next step.
3. After the batteries are inserted, the weather station will start receiving data signal from the
transmitter. The outdoor temperature data should then be displayed on the weather station. If
this does not happen after 2 minutes, the batteries will need to be removed from both units and
reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, the distance between the weather
station and the transmitter should not be more than 100 meters (see notes on "Positioning" and "868
MHz reception").
Note:
34