bürkert 8285 Bedienungsanleitung Seite 40

SMARTMEDIA
Parameter setting/System control/Software update/Load firmware
Menu Display
Release of options (Administrator)
102 Parameter sets
103 Measurement recorder
104 Logbook
106 Software update
107 AuditTrail
Return
Software update (Administrator)
Updating will change the
device characteristics. Perform
verification as appropriate!
Update firmware
Save firmware
Format card
Return
UP
Update firmware (Administrator)
Select the memory slot for
UP
the chosen firmware
(
indicates the existing version)
Slot
Abort
UP
Update firmware (Administrator)
Select the memory slot for
UP
the chosen firmware
(
indicates the existing version)
Slot
Return
40
card: Load firmware
0.003 mS/cm
25.6 °C
Inactive
Inactive
Inactive
Active
Inactive
0.003 mS/cm
20.4 °C
0.003 mS/cm
20.4 °C
1: SZ34Z10000/0-V7.0
OK
0.003 mS/cm
20.4 °C
1: SZ34Z10000/0-V7.0
Load firmware
Software update
("Load firmware")
Software update
• Insert SmartMedia card
• Open menu selection
• Parameter setting, Admin. level
• Enter passcode
• Select System control
1. Select Release of options
(Software update SW 8285-106)
Set option to "active". Enter the
TAN at the prompt. The option is
available after the TAN has been
entered.
2. Select Software update
Check whether your unit really
requires a software update!
To read the current software version,
select:
• Diagnostics
• Device description
• Module FRONT
Perform update:
• Parameter setting
• System control
• Software update
• Select slot
• Confirm slot with "OK"
• Press "Load firmware" softkey to
start software update.
8285