Inserting The Smartmedia Card - bürkert 8285 Bedienungsanleitung

Inserting the SmartMedia card

Please note when inserting the SmartMedia card:
Protect against electrostatic discharge!
The analyzer must be opened to insert or replace the SmartMedia card.
Power can remain on. When closing the device, make sure that the sealing is
properly seated and clean.
Warning!
Do not touch the terminal compartment, there may be
dangerous contact voltages!
1. Open the analyzer
• Loosen the 4 front screws
• Open the FRONT module at its right side
(pivot hinge inside at the left)
• The slit for inserting the SmartMedia card is
located at the inner side of the FRONT module
2. Insert SmartMedia card
• Remove SmartMedia card from its package
without touching the contact surface
• Insert card in the slit at the inner side of the
FRONT module
3. Remove SmartMedia card
• To avoid data loss, please call up the Maintenance
menu.
• Select "Close memory card" to terminate software
access to the SmartMedia card. Now the card can
be taken out.
Inserting the
SmartMedia card:
The label must be facing
you.
25