Mounting The Control Panel; Connecting The Electrical Power To The Generator - Dometic TEC40D Montageanleitung

Connecting the electrical power to the generator

9.5

Mounting the control panel

Please observe the following instructions for the installation location:
• Observe the length of the extension cable from the control panel to the genera-
tor.
➤ Drill the holes as shown in fig. 0, page 6.
➤ Insert the plug into the control panel.
➤ Screw on the control panel.
10 Connecting the electrical power to the
generator
D
DANGER! Danger of electrocution
Make sure there is no voltage at electrically operated components
before carrying out work on them!
I
NOTE
Observe the applicable guidelines in the country of the consumer.
10.1 Important notes on the electrical connection
• Only a qualified electrician should connect the generator to the electrical power.
• Check that the voltage specification on the type plate is the same as that of the
power supply.
• Do not lay the 230 Vw mains cable and the 12 Vg cable together in the same
cable duct.
• Do not lay cables which are loose or bent next to electrically conductive material
(metal).
• Connect the generator to a power circuit which can supply the necessary current
(see chapter "Technical data" on page 22).
18
TEC40D
EN