Adjusting The Harness And Brushcutter - McCulloch B33 B Bedienungsanweisung

a
WARNING:
Do not use a cutting attachment
without an approved guard. See the chapter on
Technical data. If an incorrect or faulty guard is
• tted this can cause serious personal injury.
n Fitting the trimmer guard
1. Install the safety cover on the shaft with the safety
cover bracket and the screws given.
2. Tighten the screws.
n Fitting the trimmer head
1. Align hole in adapter plate with hole in shaft and
install locking tool.
2. Thread cutter head onto shaft (turning it clockwise)
until it is tight.
3. Remove locking tool.
n Fitting the grass blade
1. Install the top holder (A), grass blade (B), bottom
holder (C) and washer (D) in the sequence shown.
2. Install the nut (E). Turn the nut counterclockwise
by hand until it is • nger tight. The nut has a left-
handed thread.
3. Align the holes of the gear case (F) and the top
holder and insert the hex wrench (G).
4. Use a wrench to turn the nut counterclockwise until
it is securely tightened. The tightening torque of the
locking nut must be 35-50 Nm.
5. Install the locking pin (H).

Adjusting the harness and brushcutter

a
WARNING:
When using a brush cutter it
must always be hooked securely to the harness.
Otherwise you will be unable to control the
brush cutter safely and this can result in injury to
yourself or others. Do not use a harness with a
defective quick release.
n Safety release
At the front is an easily accessible, quick release. Use
this in an emergency situation that requires you to free
yourself from the unit and harness quickly.
n Spreading the load on your shoulders
A well-adjusted harness and unit makes work much
easier. Adjust the harness for the best working
position. Tension the side straps so that the weight is
evenly distributed across both shoulders.
7