Replacing Trimmer Line - Oregon ST250 Originalbetriebsanleitung

OREGON® CORDLESS TOOL SYSTEM
TRIMMER/EDGER MODEL ST250

REPLACING TRIMMER LINE

WARNING: REMOVE THE BATTERY
PACK FROM THE TRIMMER/EDGER
BEFORE INSPECTING, CLEANING,
OR PERFORMING MAINTENANCE. A
BATTERY OPERATED TOOL WITH THE
BATTERY PACK INSERTED IS ALWAYS
ON AND CAN START ACCIDENTALLY.
The trimmer/edger is equipped with
an easy reload trimmer head It is not
necessary to disassemble the head in
order to replenish the trimmer line
OREGON® recommends rewinding with
2 0 mm Duoline+
REMOVE REMAINING TRIMMER LINE
Pull any remaining trimmer line through
an eyelet or from the top of the trimmer
head knob (Fig 20)
FIG. 20
THREAD TRIMMER LINE INTO THE
TRIMMER HEAD
• Cut a length of new trimmer line about
3–3 5 m (10–12 ft) long
• Turn the knob so the arrows point to the
eyelets on the trimmer head
AE 0213 - F/N 558938
MAINTENANCE AND CLEANING
• Insert trimmer line through one hole in
the knob and feed it through an eyelet
in the side of the trimmer head
(Fig 21A) Alternatively, insert trimmer
line through one eyelet and feed it
through a hole in the knob (Fig 21B)
FIG. 21A
FIG. 21B
• Pull the leading end of the trimmer line
until the leading end and the trailing
end are about the same length
• Thread the leading end of the trimmer
line through the other hole in the knob
It will come out through the other eyelet
in the trimmer head Pull the leading
end of the trimmer line until the leading
end and the trailing end are about the
same length (Fig 22)
FIG. 22
23