Harrie Leenders CANTA W Anleitung Seite 30

General instructions and directions
GB
Safety recommendations
Materials and tools required
1. Unpacking the stove
3. Positioning the wall bracket
6
The installation of the Canta W must be carried out by a skilled person employed by a dealer recognized by
Harrie Leenders Haardkachels.
The casing parts are susceptible to scratching. Handle them gently.
After the stove has been properly installed, burn some kindling wood to check the draught.
Glass tends to break easily, and broken glass is quite sharp. Take therefore adequate safety precautions.
For general safety, we refer to guidelines or regulations issued by a relevant official body.
Crosshead screwdriver
Box-spanner s.w. 13
Open-end wrench, j.w. 17
Hexagonal wrench 4 mm
Remove with care the jacket from the stove by
pushing it up; Don't remove the packaging yet.
Unscrew the MTI-brace from the pallet.
Remove the bolts.
Place the stove including the MTI brace on a hand-
truck (back of stove against the handtruck).
wall bracket
Determine the centre of the wall bracket.
Drill a hole at 712 mm from the floor using
a Ø6 mm masonry bit.
Use the wall bracket (as a template) and spirit level
when drilling the 5 other holes (Ø6 mm).
Ream the 6 holes using a Ø14 mm masonry bit.
Masonry bits Ø6 + Ø14
Plumb line
Sliding pieces
Spirit level
Jacket
MTI-brace
2. Ceiling or wall plate
4. Mounting the wall bracket
Handtruck
Single-walled pipe
6 expansion-shell bolts
(included)
Fasten the ceiling or wall plate using the plugs and
stucco screws provided.
Mark the centre line departing from the saw cut in
the ceiling plate (use the plumb line).
Mount the wall bracket using the expansion-shell
bolts.
Make sure it is accurately positioned using the
spirit level (A).
Stick 2x flat tape against the vertical strips from the
wall bracket.
4 S6 plugs and 4 stucco
screws (included)
2x flat tape