Hafele DTSH Montageanleitung Seite 58

G. Mount external module of Dialock DTSH door terminal
Fig. 37
Fig. 38
Fig. 39
58 Dialock Door Terminals DTSH, DTSH FH - Status: 07 .2008 - 732 .29 .134
The following prerequisites must be complied
with:
• Holes drilled as per drilling plan
• Door lock and locking cylinder inserted
If the distance between the surface of the door
leaf (outer) and the lock case is less than 6 mm a
spacer plate must be used, otherwise the external
module will be touching the lock cover .
Always use a stainless steel spacer
plate with DTSH FH - plastic is not
allowed!
1 . Before putting on the external module, check
whether the lug of the coupling part is pointing
in direction V (see fig . 36, page 57) .
2 . Insert inner square spindle into lever follower
(fig . 38) and lead connecting cable through top
hole (13 mm) . It is imperative to pay attention
to the cable routing!
3 . If a mortise lock with emergency opening log-
ging is being used, attach connecting cable to
connector in external module and roll up con-
necting cable in the 32 mm recess .
Installation Instructions