Troubleshooting, Eliminating Faults; Removal - SCHUNK KSC-D 125 Montage- Und Betriebsanleitung

_________________________________________________________________________________________
6

Troubleshooting, eliminating faults

Clamping using the lateral clamping screw (pos. 230) is not possible
The clamping element on the inside is not in the correct position.
See Section 8 Assembly
Unable to disassemble the carriage unit from the tool body
 The clamping screw (pos. 230) has not been unscrewed far enough.
 The inside of the vice is very dirty.
→ Clean the entire tool body through the blow-out holes on the front slider after having
disassembled the central jaw. (pos. 70)
Important: vice functions can exclusively be guaranteed if the central jaw has been installed.
 Cylinder screw (pos. 160) has not been removed.
7

Removal

Removing the carriage unit
 Removing the system jaws.
 Remove the cylinder screw (pos. 160).
 Undo the clamping screw (pos. 230) by a minimum of 4 turns.
Cylinder screw (pos. 40) must never be unfastened.
 Pull the entire carriage unit from the tool body.
schunk.com XND.00033.002_A – 10/2018 34