Connect The Wires To The Fence Transmitter; Prepare The Receiver Collar - Petsafe In-Ground Cat Fence Betriebsanleitung Und Trainingsanleitung

Additional B oundary Wire
We recommend the use of 20 gauge insulated multi-strand copper
wire for direct burial. Extra Boundary Wire can be purchased in 150 m
(500 ft) spools at the store where you purchased the kit or through the
Customer Care Centre.
Note: When adding Boundary Wire, it must act as a continuous loop.
The table at right indicates the approximate length of Boundary Wire
needed for a rectangular, Single Loop layout. Length will vary due to
the amount of twisted wire and layout used.
__________________________________________________

Connect the Wires to the Fence Transmitter

Step
4
Boundary Wire
1. Run the Boundary Wire to the Fence Transmitter through a window, under
a door, through a crawl space vent, or any other appropriate available access.
You can also drill a hole through your wall.
2. Strip the ends of the Boundary Wire approximately 1.3 cm (1/2 in).
3. Insert the Boundary Wires into the Boundary Wire Terminals on the Fence
Transmitter.
4. Turn the Boundary Width Control knob to 10. This will set the Warning Zone
at the maximum width.
5. Plug the Power Adapter into the Power Jack and a working outlet.
6. The Power Light and Loop Indicator Lights should come on. If this does not
happen, see the "Troubleshooting" section.
__________________________________________________

Prepare the Receiver Collar

Step
5 Your Receiver Collar comes with short Contact Points installed. Use the long Contact Points for cats with long or
thick hair. Tighten the Contact Points with pliers one-half turn beyond finger tight (5A). Check the tightness weekly.
To Insert and Remove the Batteries
1. With a coin, unlock the Battery Door and remove it (5B).
2. Insert two 3-volt Lithium (CR2032 batteries) into the Battery Door (5B).
3. Place the Battery Door back into the Receiver (5C).
4. With a coin, slide Battery Door latch to lock it (5C).
Replacement batteries
(3-volt, CR2032) can
be found at many
retailers. Contact the
Customer Care Centre
or visit our website at
www.petsafe.net for a
list of common retailers.
8
Downloaded from www.Manualslib.com
(4A)
5A
2
3
manuals search engine
5B
2
3
www.petsafe.net
Area to be Approximate wire
enclosed length required
Ares Acres Metres
10 1/4 127
13 1/3 146
20 1/2 180
40 1 255
80 2 360
200 5 570
400 10 800
600 15 1000
800 20 1100
900 22 1200
4A
Loop Indicator
Light
Power Light
Power
Boundary Width
Jack
Control
5C
Feet
415
480
590
835
1180
1870
2600
3200
3700
4000
}
Boundary Wire
Terminals