GB2
DELIVERY AND TRANSPORT
Every machine is supplied in its original packaging. Please check the contents carefully.
Before disposing the packaging material, please set machine into operation to make sure that no parts are
left in the packaging.
Action to be taken when damaged during transport (even when the packaging is undamaged):
Damage which occured during transport and which is n ot discovered under normal circumstances or which is
reported too late, cannot be recovered.
Therefore please check the consignment immediately !
Should the consignment be damaged on the outside, a complaint should be made on acceptance and the
damage should bereported (copy to supplier). If damage is discovered after unpacking, a statement
of the facts or negotiated letter should be sent immediately to the carriers. In this case, the packaging
must be kept.
The following periods for notifying damage should be observed for ensuring a claim against the carrier:
Railway
Forwarding agent
Mail
In the event of damage an acknowledgement from the carrier on type and cause of damage is necessary.
All other damage, for which one of the above mentioned occurences cannot be proved, is attributable
to the consignee or goes against transport insurance, if such was taken.
INSTALLATION
The device can be installed in each normal work-room. Please be careful to keep the machines away from
dust, steam and splashed water. These can cause malfunction of the machine. The device must not be
assembled and used in explosion-hazardous areas.
ELECTRICAL CONNECTION
ATTENTION !
The machine is only to be connected after you are sure of the conformity of the mains voltage and the
voltage figures on the machine type plate. Only the switched-off machine may be connected with the supply mains.
ATTENTION !
In case of any repair on the machine or on the power supply unit, first of all, pull out the power plug.
Please only use plug connectors and plugs that are properly grounded.
Version 1.02
:
within 7 days
:
within 4 days
:
within 24 hrs
hd 260
0.992.016GB