WARNING! COMPRESSED AIR CAN BE DANGEROUS. WEAR EYE PROTECTION
WHEN VENTING ANY AIR. COMPRESSED AIR MAY DAMAGE THE EYES OR
CAUSE VISION PROBLEMS.
19.7.
Replacing the inlet filter and pre-filter
(Fig. 18)
The inlet filter is located inside the compressor crankcase cover.
Inlet filter replacement:
Pull out the rubber plug by hand (2).
Remove the used filter (1).
Insert a new filter and replace the
rubber plug.
Pre-filter replacement:
Pull out the pre-filter by hand (3).
Replace the element and re-insert.
19.8.
Filter element replacement
(Fig. 19)
Remove the hose (1) from the quick connector.
Use a wrench (2) to release the filter vessel (3) and remove.
Pull down on the filter element (4) to remove.
Insert a new filter element.
Re-install the filter vessel.
Gently tighten the filter vessel with the wrench.
Re-install the hose on the quick connector.
Fig. 19
NP-DK50 2x2V 110-2_10-2018-MD A
Fig. 18
1
- 32 -
3
2
DK50 2x2V/110
4
10/2018