Fuels/Refueling - Dolmar HT-2460 Bedienungsanleitung

FUELS/REFUELING

Fuel and oil mixture
- The engine of the hedge Trimmer is a high-efficiency two-stroke engine.
It is run with a mixture of fuel and two-stroke engine oil. The engine is designed
for unleaded regular fuel with a min. -octane value of 91 ROZ.
In case no such fuel is available, you can use fuel with a higher octane value.
This will not damage the engine, but may cause poor operating behaviour.
A similar situation will arise from the use of leaded fuel.
To obtain optimum engine operation and to protect your health and the
environment, only unleaded fuel should be used!
- For lubricating the engine use a two-stroke engine oil (quality grade: TSC-3),
which is added to the fuel.
The engine has been designed for use with DOLMAR two-stroke engine oil
and a mixture ratio of 50:1 only to protect the environment. In addition, a long
service life and a reliable operation with a minimum emission of exhaust gases is
guaranteed. It is absolutely essential to observe a mixture ratio of 50:1 (DOLMAR
2-stroke engine oil), otherwise the reliable function of the Hedge Trimmer cannot
be guaranteed.
- The correct mixture ratio:
Gasoline: Specified two-stroke engine oil = 50 : 1 or
Gasoline: Other manufacturer's two-stroke engine oil = 25 : 1
recommended
NOTE: For preparing the fuel-oil mixture, first mix the entire oil quantity with half of
the fuel required. In an approved can which meets or exceeds all local code
standards, then add the remaining fuel.
Thoroughly shake the mixture before filling it into the Hedge Trimmer's tank.
It is not wise to add more engine oil than specified to ensure safe operation.
It will only result in a higher production of combustion residues which
will pollute the environment and clog the exhaust channel in the cylinder
as well as the muffler. In addition, the fuel consumption will rise and the
performance will decrease.
Handling petroleum products
Utmost care is required when handling fuel. Fuel may contain substances similar
to solvents. Refuel either in a well ventilated area or outdoors. Do not inhale fuel
vapors, avoid any contact of fuel or oil with your skin.
If your skin comes in contact with these substances repeatedly and for an extended
period of time, it will desiccate.
Various skin diseases may result. In addition, allergic reactions are known to occur.
Eyes can be irritated by contact with oil, fuel etc.
If oil, fuel, etc., comes into your eyes, immediately wash them with clear water.
If your eyes are still irritated, see a doctor immediately!
Observe the Safety Instructions on page 5.
Gasoline
1,000 cm
5,000 cm
10,000 cm
9
Oil
50:1
+
50:1
3 3
(1 litter) 20 cm
3 3
(5 litter) 100 cm
3 (10 litter) 200 cm 3
25:1
3
40 cm
3
200 cm
400 cm 3