Operating Elements; Control Panel - Dometic MCS6 Bedienungsanleitung

Operating elements

6 Operating elements
6.1

Control Panel

Key to fig. 1, page 2:
Item Name
1 Power Button
Fan
2 Button
3 Down Button
4 Faceplate sensor
5 Up Button
6 Display
7 LED "Heat Mode"
6
Description
Press and release to toggle between the On
and Off Modes.
Press to advance through the available fan
settings. "1"(lowest) through "6" (highest) indi-
cates Manual Fan Speeds.
The letter "a" indicates automatic fan operation
selected.
Press and release to display the set point.
Press and hold the Down Button to decrease
the set point. Set point is decreased one
degree each time the button is depressed.
The faceplate sensor will read the room
temperature unless a remote air sensor is
installed.
Press and release to display the set point.
Press and hold the Up Button to increase the
set point. Set point is increased one degree
each time the button is depressed.
The inside air temperature is displayed when
the control is on. The set point is displayed
when either Up or Down Button is pressed.
The display also indicates program information
and fault codes.
When the control resumes operation after a
power interruption all the display LEDs will turn
on for one second. This is normal operating
condition and is referred to as Power On
Reset.
This LED is lit when
– the Heat Only Mode is selected
– or the unit is in a heating cycle.
MCS6, MCS12, MCS16
EN