Specifications - Rotel RMB-1066 Bedienungsanleitung

9

Specifications

Continuous Power Output Stereo Mode
(20-20 kHz, < 0.03% THD)
Continuous Power Output Bridged Mono Mode
(20-20 kHz, < 0.1% THD)
Total Harmonic Distortion
(20Hz-20kHz, 8 ohms)
Intermodulation Distortion
(60 Hz : 7 kHz, 4:1)
Frequency Response (± 1 dB)
Damping Factor (20-20,000 Hz, 8 ohms)
Speaker Impedance (combined load)
Stereo mode:
Bridged Mono mode:
Signal to Noise Ratio (IHF A network)
Input Impedance
Input Sensitivity
Auto Turn On Threshold Level (if activated)
Auto Turn Off Delay Time (if activated)
Power Requirements
USA:
Europe:
Power Consumption
Dimensions (W x H x D)
Weight (net)
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
English
60 watts/ch into 8 ohms
150 watts/ch into 8 ohms
< 0.03%
< 0.03%
15Hz–100kHz
150
4 ohms minimum
8 ohms minimum
116 dB
22 k ohms
1.5 volt
10 mV input signal
5 minutes with no signal
115 Volts, 60 Hz
230 Volts, 50 Hz
700 Watts
430 x 121 x 435 mm
16 / x 4 / x 17 / in
15 3 1
16 4 8
13.5 kg, 29.75 lb.