Start Up; Power Connection; Operation; Adjust Handle - Kärcher BDS 43/180 C Originalbetriebsanleitung

Start up

 The power cord must be checked regu-
larly for damages, such as cracks or ag-
ing. If damage is found, the cable must
be replaced before further use.
 Check appliance for damage, have
damages repaired by customer service.

Power connection

– For connection values, see technical
data and type plate.
– The electrical connections must be done by
an electrician according to IEC 60364-1.
DANGER
Risk of electric shock.
– Do not drive over the mains cable.
DANGER
Risk of injury!
– Never wrap the mains cable around
your body or your neck.
– Do not let the mains cable come in con-
tact with the rotating brushes or rotating
pads.
Attach the brush/pad
 Disconnect the mains plug from the
socket.
 Loosen the clamps of the level adjust-
ment.
 Swivel the tension lever to the front into
a horizontal position.
 Tighten the clamps of the level adjust-
ment.
 Tilt the appliance rearward.
 Place the disc brush/driver plate onto
the actuator and turn in anti-clockwise
direction.
Fill the detergent tank (option)
WARNING
Risk of damage. Only use the recommend-
ed detergents. With other detergents, the
operator bears the increased risk regarding
the operational safety and danger of acci-
dent.
Only use detergents that are free from sol-
vents, hydrochloric acid and hydrofluoric
acid.
Follow the safety instructions for using de-
tergents.
 Fill detergent solution into the detergent
tank.
WARNING
Risk of injury! The operation of the appli-
ance requires practice.
– Ensure that there are no obstacles in
the area to be cleaned.
– Check the floor consistency for its suit-
ability.
– The handling becomes more difficult
with uneven or rough surfaces.
WARNING
Risk of accident due to loss of control over
the appliance. Do not adjust the handle un-
less the motor is at a standstill.
 Loosen the clamps of the level adjust-
ment.
 Tilt the handle into a comfortable posi-
tion (arms outstretched).
 Tighten the clamps of the level adjust-
ment.
Turning on the Appliance
ATTENTION
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
 Insert the mains plug into a socket.
 Set handle to working height.
 Hold the handle with both hands.
 Press and hold the unlocking button.
 Use the ON/OFF switch.
 Release the unlocking button.
– 3
EN

Operation

Adjust handle

11