Playing Records - auna Belle Epoque Anschluss- Und Anwendungshinweise

This system includes a full-size, 3-speed, belt-drive turntable. You can play 33, 45 and 78 rpm records.
• Press POWER and set the volume to a low level.Press PHONO/FUNCTION to enter the PHONO mode.
• Make sure that you have removed the stylus cover from the stylus and have released the tone arm lock
that secured the tone arm to the tone arm rest.
• Set the turntable speed selector to the appropriate speed 33, 45 or 78 rpm. If you are playing 45 rpm
‚singles', place the 45 rpm adapter on the center spindle.
• Place your record on the center spindle.
• Raise the cue lever to lift the tone arm off its rest. Move the tone arm to the edge of the record. The
turntable starts automatically. Use the cue lever to gently lower the tone arm onto the record.
• Adjust the VOLUME control to the desired level.
• When the tone arm reaches the end of the record it automatically returns to the tone arm rest and the
record player stops.
• To turn the system ‚off', press the POWER button 3 seconds and the POWER indicator goes ‚off'.
NOTE: Do not turn or stop the turntable manually. Moving or jarring the turntable without securing the tone
arm clamp could result in damage to the tone arm.
IMPORTANT: To protect the turntable from damage during transportation, a silver transit screw is
located at the upper right of the turntable. BEFORE PLAYING A RECORD, use a screwdriver to turn the
screw CLOCKWISE (DOWN!) completely.
Changing the stylus
The jeweled stylus that was installed in your turntable at the time of purchase should last for up to 300
hours of playback with 33 RPM albums or 45 RPM ‚singles'. Lf you are playing older 78 RPM records, which
are made from a much harder material, the stylus life expectancy will be reduced.
When the playback sound becomes distorted and unsatisfactory, first check to see if any dust or lint has ac-
cumulated on the stylus. If you see any visible foreign matter on the tip of the stylus, remove it very carefully
with a soft stylus-cleaning brush.
If there is no visible foreign matter on the stylus and the sound is still unsatisfactory the stylus is probably
worn and needs to be replaced. If you continue playing your re cords with a worn stylus you may eventually
cause damage to the records themselves.
• Lift the tone arm off the tone arm rest.
• At the front end of the tone arm, place the tip of your fingernail between the red stylus Holder and the
black cartridge housing as shown, and press down on the red stylus. Holder until it separates from the
cartridge housing.
• Completely remove the red stylus holder with worn stylus and discard it.
• Place the new red stylus holder with stylus under the cartridge housing. Press up ward on the back
side of the stylus holder first and then press up on the front edge of the stylus holder until it snaps into
place on the cartridge housing.
IMPORTANT: Avoid touching the tip of the stylus itself.
28

Playing Records