Electronic Control Board • Autotest - AERMEC FW130R Installationsanleitung

ELECTRONIC CONTROL BOARD
WARNING
Dip SW1
1
BR26 alternative heating
2
Electrical heater BR26
3
Hot water coil BVR1
4
Pre-set in factory
5
Heat pump
6
Fan thermostat control
7
NC external contact
8
External contact = Alarm ( ** )
Dip SW2 Pre-set in factory
(*) = External contact in normal conditions = ON mode
(**) = External contact in normal conditions = Alarm not present
AUTOTEST
If the AUX button is pressed for more than 5 seconds, a self-test program will start
up; the LED will commence a series of flashes (see the Alarm code table).
Users are advised not to initiate this function.
To restore normal unit operation, switch it off then back on by means of the
remote controller.
ON OFF
BR26 Integrated and alternative heating
Normal
Normal
Cooling only
Continuous fan ventilation
NO external contact
External contact = On Off Remote ( * )
FWR 1406 - 5388000_02
31