Technical Assistance - Warranty; Technical Characteristics - Extel VisioSmart Installations- Und Bedienungsanleitung

Detection mode: allows you to activate movement detection, using either infra-red detection (PIR) or successive
image comparison (software). This mode is not recommended in a heavily frequented area.
Timestamp: allows you to personalise the video's timestamp.
Email: allows you to configure notifications by email.
Formatting the SD card: allows you to format the SD card.
Rewriting the SD card: enables the automatic deletion of old files when the SD card is full.
Device profile settings: allows you to save the device settings or change the saved settings.
Device information: displays the software version and the state of the SD memory card.
Bell volume settings: allows you to adjust the intercom bell volume.
Change ringtone: allows you to choose the intercom bell ringtone.
Door bell activated: function not used.

10. TECHNICAL CHARACTERISTICS

WiFi: IEE 802.11 b/g/n, 2.4 GHz
Viewing angle: H=90°, V=50°
Video resolution: 720p/VGA/CIF, 25 FPS
Memory: micro-SD class 10 up to 128 GB
Protection rating: IP55
Night vision: 3 infrared LEDs, 1 dusk-to-dawn sensor
Strike plate control: 12 V - 1 A maximum
Gate control: breaking capacity: 12 V - 2 A
Adaptor: 100-240 V~ - 50/60 Hz 15 V - 1.5 A
Maximum consumption: 22.5 W
Operating temperature: - 10°C/+45°C
Dimensions with shield (mm): 160 x 67 x 47

11. TECHNICAL ASSISTANCE - WARRANTY

Problem
• The application cannot find
the device.
• The WiFi router is not dis-
played in the drop-down
menu.
• No image is displayed
GB9
Solution
- Make sure the intercom panel is plugged in.
- Make sure the WiFi router is on.
- Make sure the intercom and the mobile device are both connected to the
same router during the initial set up.
- Make sure the WiFi router is on and set to 2.4 GHz.
- Change the WiFi router's wireless security protocol to WPA/WPA2/
WPA2-PSK. For security reasons, WEP protocol is not recommended.
- Make sure the power supply unit is not damaged or defective and is
plugged in to a working power outlet.
- Make sure the intercom is properly configured in the application.
- Make sure the mobile device is properly connected to a 3G/4G WiFi
network.
- Make sure the intercom is located in an area with WiFi coverage from
your router.
CFI EXTEL - VISIOSMART - 09/2017