Product Reactivation After Cleansing; Resetting Filter Alarm For Duo Ewireless; Removing Batteries´ Protective Foil For Remote Control - Südwind AMBIENTIKA SOLO Handbuch Für Installation Und Wartung

6.3 PRODUCT REACTIVATION AFTER CLEANSING

Replace the main unit (3), together with the specific shutter (2) and the esthetic front cover (1),
onto the wall mounting (4i).
ATTENTION: If you clean several products at a time, replace each main unit in conformity with their
initial location, in order to avoid problems of communication between master units and slave ones.
SOLO VERSION
It is sufficient to reinstall the main unit on the wall and turn the product on, by using the main
switch.
ADVANCED VERSION
Once the main unit is reinstalled in its place on the wall, turn the product on by means of the main
switch. To reset the cleansing tally, it is necessary to act via the remote controller.
(Instructions on implementation of reset after the filter cleansing, are present in the manual of
remote controller instructions)
WIRELESS VERSION
Once the main unit is reinstalled in its place on the wall, turn the product on by means of the main
switch. To reset the cleansing tally, it is necessary to act via remote controller.
(Instructions on implementation of reset after the filter cleansing, are present in the manual of
remote controller instructions)
6.4 RESETTING ALARM FOR DUO AND
Every 2000 operating hours, the product will stop working and the luminous indicator, placed in the
lower right corner, will emit a continuous luminous red signal. Carry out cleansing of the exchanger
and the filters, as specified in the paragraph. Replace the filters when necessary.
In the case of more than one connected product the RESET must be done by the MASTER-product.
6.5 REMOVING BATTERIES ' PROTECTIVE FOIL FOR REMOTE CONTROL
For using the remote control pick off the protective foile.
104
WIRELESS
2x + 2x + 2x