Safety Instructions For Spray Guns - WAGNER WallPerfect W 665 I-Spray Originalbetriebsanleitung

WallPerfect W 665 I-Spray

3. Safety Instructions for Spray Guns

•
Caution! Wear breathing equipment: Paint mist and solvent vapors are damaging to
health. Always wear breathing equipment and only work in well ventilated rooms or
using supplementary ventilating equipment. It is advisable to wear working clothing,
safety glasses, ear protection and gloves.
CAUTION: DANGER OF INJURY!
Never point the spray stream towards human beings or animals.
Sockets and plugs must be masked. Risk of an electric shock as a
consequence of sprayed material entering the socket!
•
Do not use the spray guns to spray flammable substances.
•
The spray guns are not to be cleaned with flammable solvents.
•
Caution against dangers that can arise from the sprayed substance and observe the
text and information on the containers or the specifications given by the substance
manufacturer.
•
Do not spray any liquid of unknown hazard potential.
•
The device may not be used in workplaces covered by the explosion-protection
regulations.
•
To avoid the hazard of explosion when spraying, provide for effective natural or
artificial ventilation.
•
There must be no sources of ignition such as, for example, open fires, smoke of lit
cigarettes, cigars and tobacco pipes, sparks, glowing wires, hot surfaces, etc. in the
vicinity during spraying.
•
Ensure that no solvent vapors are sucked in by the unit. Do not spray onto the unit!
•
The spray gun is not a toy; children must therefore not be allowed to handle it or play
with it.
•
Before working on the spray gun remove the power plug from the socket.
•
Cover areas that are
example, may transport paint mist over great distances and cause damage.
•
The units may only be used with a functional valve.
hose (Fig. 1, item 18) do not operate the unit further! Dismantle and clean the
ventilating hose, valve and diaphragm and replace the diaphragm if necessary.
•
Do not lay the spray gun.
•
The device is equipped with a thermal release which disconnects the device in case of
overheating. In this case, turn off the device, remove the plug and let the device cool
down for at least 1/2 hour. Eliminate the cause of heating, e.g. bent hose, soiled air filter,
slots for air intake covered.
With original WAGNER accessories and spare parts, you have the guarantee that all
safety regulations are fulfilled.
not to be sprayed. When working keep in mind that wind, for
If paints rises in the ventilating
GB
21