AEG S93880KMB3 Benutzerinformation Seite 35

Problem
Only gas comes out when
dispensing carbonated wa-
ter.
Dispensing is interrupted af-
ter a short time.
The "Water circuit cleaning"
and "Still cold water" indica-
tors are shown.
The buzzer sounds. The
"Alarm" icon and "Extra Hu-
midity" icons are flashing.
The water filter indicator
flashes.
The water filter indicator
lights constantly.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Sediment in the water.
Water supply obstructed.
Sediment in the water.
The maximum time of two
minutes is exceeded.
No water has been dis-
pensed in 10 days.
Failed water supplies.
Dispensing water more
than 2 minutes.
The filter has been totally
consumed.
20% of filter capacity re-
mains.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
Food products placed in
the appliance were too
warm.
Many food products were
put in at the same time.
The door has been
opened often.
The COOLMATIC function
is switched on.
There is no cold air circula-
tion in the appliance.
ENGLISH
Solution
Remove and clean the strainer
in the inlet hose connection.
Check water supply.
Remove and clean the strainer
in the inlet hose connection.
Start new dispensing.
Dispense water in total 2 mi-
nutes and the icons goes off.
"Press any button to reset the
alarm. Select still cold water
and push the water dispensing
lever and release. The water
pump start and filling the wa-
ter system. After a few minutes
the icons goes off.
Release the water dispensing
lever and press any button to
reset the alarm. Start new dis-
pensing.
Refer to "Replacing the water
filter".
Buy a new filter.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Allow food products to cool to
room temperature before stor-
ing.
Wait some hours and then
check the temperature again.
Open the door only if necessa-
ry.
Refer to "COOLMATIC func-
tion".
Make sure that there is cold air
circulation in the appliance.
35