Adding/Deleting Somfy Io Control Points And Io Sensors; Replacing A Lost Or Broken Io-Homecontrol® Somfy Control Point; Tips And Recommendations; Questions On The Slim Io Receiver Pergola + Plug - SOMFY SLIM IO PERGOLA+PLUG Anleitung

Slim io Receiver Pergola + Plug
5.3.3. Modifying the favourite position (my)
1) Place the motorised product in the required new favourite
position (my).
2) Press the "my" button on the control button until the motorised
product moves.
The new favourite position (my) has been programmed.
5.3.4. Deleting the favourite position (my)
1) Briefly press the "my" button.
The motorised product will start to move and stop in the
favourite position (my).
2) Press the "my" button on the control button until the motorised
product moves.
The favourite position (my) has been deleted.

5.4. ADDING/DELETING SOMFY IO CONTROL POINTS AND IO SENSORS

Refer to the corresponding guide.
5.5. REPLACING A LOST OR BROKEN IO-HOMECONTROL® SOMFY CONTROL
POINT
To replace a lost or broken io-homecontrol® control point, consult a home motorisation and
automation professional.

6. TIPS AND RECOMMENDATIONS

6.1. QUESTIONS ON THE SLIM IO RECEIVER PERGOLA + PLUG

Observations
The wiring is incorrect.
The motor is in heat protection
mode.
The motorised
The Somfy io control point battery
product does not
is low.
operate.
The control point is not compatible.
The Somfy io control point used
has not been programmed into the
receiver.
The motorised The end limits have been incorrectly
product stops too set.
soon or too late.
The "my" position is The "my" position is deleted.
not working.
I can't delete the Your control point is too old (Index E
"my" position with or older).
my Easy Sun io
control point.
Copyright © 2017 SOMFY ACTIVITE SA, Société Anonyme.. All rights reserved.
Possible causes
or
or
Solutions
Check the wiring of the the Slim io
Receiver Pergola + Plug and modify
it if necessary.
Wait until the motor cools down.
Check whether the battery is weak
and replace it if necessary.
Check for compatibility and replace
the control point if necessary.
Use a programmed control point or
program this control point.
Readjust the end limits.
Program the "my" position.
Delete the "my" position with
another paired control point.
EN
my
my
27