Technical Data - SOMFY S&SO-RS100 io HYBRID Anleitung

EN
If the roller shutter apron comes up against an obstacle
-
when moving down then, depending on the position of
the obstacle:
• Either the roller shutter stops automatically.
• Or it stops and is raised again automatically.
If an obstacle is detected following an automatic order (initiated by a clock, a sensor,
or TaHoma), the down order is automatically repeated. If the obstacle is found once again,
the roller shutter stops and rises automatically.
3.3.3. Frost protection when moving upwards
If the S&SO-RS100 io HYBRID detects resistance, it stops automatically to protect the roller
-
shutter apron: the roller shutter remains in its initial position.
3.3.4. Replacing a lost or broken Somfy io-homecontrol
To replace a lost or broken io-homecontrol
automation professional.

4. TECHNICAL DATA

Radio frequency
Frequency bands and Maximum power
used
Power supply
Operating temperature
Protection rating
Maximum number of control points
associated sensors
Safety level
Somfy SAS, F-74300 CLUSES hereby declares, as the manufacturer, that the drive covered by these instructions, marked for
input voltage 230 V~50 Hz and used as set out in these instructions, is in compliance with the essential requirements of
the applicable European Directives and in particular of the Machinery Directive 2006/42/EC and EMC Directive 2014/53/EC.
The full text of the EU Declaration of Conformity is available at www.somfy.com/ce.
Antoine Crézé, Approval manager, acting on behalf of the Business Director, Cluses, 11/2016.
64
Copyright © 2014 - 2016 Somfy SAS. All rights reserved.
control point
®
control point, contact a home motorisation or
®
868-870 MHz io-homecontrol
868.000 MHz - 868.600 MHz p.a.r. <25 mW
868.700 MHz - 869.200 MHz p.a.r. <25 mW
869.700 MHz - 870.000 MHz p.a.r. <25 mW
230 V 50 Hz
-25°C to 60 °C
IP 44
and
9
Category II
two-way Tri-band
®
Non contractual images.