Trix RP 25 Bedienungsanleitung Seite 27

We recommend that you always change just one
G
setting value and see what effect this has.
G Before changing parameters, you must remove
any smoke generators that have been fitted.
Programming table of the most important CVs
CV Designation
1 Locomotive address
2 Starting voltage
3 Acceleration time
4 Braking time
5 Top speed
6 Middle speed
8 Basic setting
Meaning
DCC address of the locomotive
Changes the minimum speed
Value * 0.87 gives the time
from shutdown to top speed
Value * 0.87 gives the time
from top speed to shutdown
Speed of the locomotive
at the top speed level
Speed of the locomotive at the middle speed level.
CV 6 must be less than CV 5
8 = Restore basic
factory settings
CV 8 is an important CV. Writing the value "8" will
G
result in the complete component being reset to the
factory settings that applied at the time of delivery!
Area Factory setting
1 – 119 3
0 – 63 4
0 – 63 8
0 – 63 6
0 – 63 63
0 – 63 25
8 –
27