Switching On Vox Mode - switel WT227 Bedienungsanleitung

This will indicate to the other subscriber that you have finished
speaking and are waiting for a reply.
The volume of the incoming call signal depends on your volume
setting. 10 volume levels can be set using the
Note: While you are holding the PTT button, you will not be
able to hear any incoming calls. As is usual with radio units,
only one of the two participants in the call can speak at any
one time.
Therefore, always wait until you hear the signal tone before pressing
the PTT button again.
While you are pressing the PTT button, the
the display. When you receive a call, the
display.
3.6

Switching on VOX mode

In VOX mode, the radio will automatically start to transmit as soon as
your voice or another noise is detected. It is not necessary to press
the PTT button. Transmission will always take place for 2 seconds,
even when you speak for less than 2 seconds.
Two sensitivity levels (Hi/Lo) can be set for VOX mode. With setting
Hi, even softer noises will be transmitted whereas, with setting Lo,
only loud signals will be sent. In setting Off, VOX mode is switched off
(standard setting).
52
- Operation -
and buttons.
symbol will appear in
symbol will appear in the