Baby Mode; Timer Setting; Humidity Control; Night Light - Klarstein Cubix Anleitung

BABY MODE

• Touch the symbol BABY MODE
• WARM MIST and UV functions are also active. Display shows the baby mode
symbol , warm mist symbol
achieve a humidity of 55%RH at maximum power.
• After the humidity of 55%RH has been achieved, the device switches to minimum
power.
• WARM MIST, UV, PLASMA, and TIMER SETING function can be used in baby
mode.
• The device checks the humidity level every 1 minute.

TIMER SETTING

There are 12 timer setting: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 1 1, 12 hours. Touch the symbol
TIMER l . The LED display will show the desired timer setting. Touch until "Co" is
displayed on the LED. The timer setting is cancelled. The timer shows the remaining
time of operation and decreases by 1 hour, i.e., if the timer is set for 12 hours, the LED
display shows 1 1 after one hour. Touch TIMER symbol to see what time has been set.
Touch again to set timer again.
Mist function
Touch the symbol HEATING
minutes. The symbol appears on the LED display. Touch again to stop the function.
Mist will become cool.

Humidity Control

Constant humidity: Before you touch the symbol HUMIDITY
the current humidity. You may set the humidity from 30%RH to 75%RH. Touch once, and
AUTO mode is cancelled. Humidity will increase by 5%RH. When it reaches 75%RH,
touch again, and it will display "Co" and flash for 3 seconds to exit the humidity setting
function. After you set the desired humidity, the unit will store it and confirm this setting
after 5 seconds. After 5 more seconds, the symbol %RH will blink. The LED display
shows the current humidity. Touch again, and it shows the desired humidity setting. If the
desired humidity is less than the current humidity, the unit will remain in the sleep mode.
But if the desired humidity is higher than the current humidity, the humidify function will
start. Mist output speed cannot be setting during the constant humidity mode.
Long-press the symbol or
Plasma generator
Touch the symbol PLASMA
shows the same symbol. Touch again to stop the function.

Night light

Long-press the symbol PLASMA
on or off.
, to select baby mode.
, and UV symbol . The device begins operating to
. The warm mist will begin coming out after 10–15
, to cancel auto humidity and enter AUTO mode.
. The Plasma generator begins operation. The LED display
.This controls the night light on the base, switching it
the LED display shows
EN
23