Technical Data - Hilti SB 4-A22 Bedienungsanleitung

3.4 Possible misuse
▶ Do not use the power tool to cut bricks, concrete, cellular concrete, natural stone or tiles.
▶ Do not use the product to cut pipes containing liquids.
▶ Do not saw into unknown materials.
3.5 Li­ion battery status indicator
The charge state of the Li-ion battery and malfunctions of the power tool are indicated by the indicator of
the Li­ion battery. Press either of the battery release buttons to check the charge state of the Li­Ion battery.
Status
4 LEDs light up.
3 LEDs light up.
2 LEDs light up.
1 LED lights up.
1 LED flashes.
1 LED flashes, the power tool is not in working or-
der.
4 LEDs flash, the power tool is not in working or-
der.
Battery charge state cannot be indicated while the control switch is pressed and for 5 seconds after
the control switch has been released. If the LEDs of the charge state indicator flash, follow the
instructions in the 'Troubleshooting' section.
3.6 Items supplied.
Bandsaw, operating instructions.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Center or online at: www.hilti.com
4

Technical data

4.1 Bandsaw
Rated voltage
Ambient temperature
Weight in accordance with EPTA procedure 01
No-load speed
Max. cutting depth
Bandsaw blade (Length x width x thickness)
4.2 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the electric tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
18 English
Printed: 29.05.2018 | Doc-Nr: PUB / 5310781 / 000 / 05
Meaning
• Charge state: 75 % to 100 %
• Charge state: 50 % to 75 %
• Charge state: 25 % to 50 %
• Charge state: 10 % to 25 %
• Charge state: < 10 %
• The battery has overheated or is completely
discharged.
• The power tool is overloaded or has overheated.
SB 4-A22
21.6 V
−17 ℃ ... 60 ℃
4 kg
167 m/min
63.5 mm
733 mm x 12.7 mm x 0.5 mm
2145463
*2145463*