Possible Faults; Technical Data - ATIKA HS 710/61 Originalbetriebsanleitung

Possible faults

Fault
Hedge trimmer does not work.
Hedge trimmer cuts with
interruptions
Motor is running, knives do not
move
Knives get hot
Motor is humming, knives do
not move

In case of further faults or inquiries please contact your local dealer.

Technical Data

Type / Model
Year of construction
Motor output P
1
Mains voltage / Mains frequency
No-load speed n
0
Length of knives
Cutting length
Thickness of blade
Cutting distance
Adjustment of handhold
Hand-arm vibration front *
Hand-arm vibration rear *
Sound power level L *
WA
Sound pressure level L *
PA
Weight
Protection class
* (according to DIN EN 60745-1 and DIN EN 60745-2-15)
Possible cause
• No power
• Power failure
• Extension cable defect
• Safety fuse defect
• Motor or switch defect
• Cable defect
• Internal failure
• Circuit closer/breaker defect
• Internal failure
• Knives are edgeless
• Knives are defect
• Missing lubrication ⇒ friction
• Knives are blocking
Removal (disconnect power plug)
• Check cable, no longer use defect cable protection
• Check cable, no longer use defect cable protection
• Check power supply, power outlet, fuse
• Replace fuse
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Check cable, no longer use defect cable protection
• Manufacturer or responsible customer service
respectively must be called
• Manufacturer or responsible customer service
respectively must be called
• Manufacturer or responsible customer service
respectively must be called
• Arrange sharpening of knives
• Exchange knives
• Lubricating of knives
• Remove object
 HS 710/61
 see last page
 710 W
 230 – 240 V~ / 50 Hz
 1600 min
–1
 610 mm
 534 mm
 1.8 mm
 22 mm
 ± 90° (180°)
 a = 3.781m/s²; K = 1.5 m/s²
h
 a = 3.991m/s²; K = 1.5 m/s²
h
 99.27 dB (A); K = 3 dB (A)
 91.31 dB (A); K = 3 dB (A)
 approx. 3.9 kg
 II
19
Technical modifications reserved!