Danfoss VLT AQUA Drive Produkthandbuch Seite 127

®
VLT AQUA Drive
Produkthandbuch
Efficient Parameter Set-up for Water Ap-
plications
The parameters can easily be set up for the vast majority of the water and wastewater applications
only by using the [Quick Menu].
The best way to set parameters using the [Quick Menu] is by following the steps below:
1.
2.
3.
It is recommended to do the set-up in the order listed.
Select
grammed as personal parameters. For example, a pump or equipment OEM may have pre-
programmed these to be in My Personal Menu during factory commissioning to make on-site
commissioning / fine tuning simpler. These parameters are selected in parameter 0-25
Menu
. Up to 20 different parameters can be defined in this menu.
Abbildung 9.1: Quick menu view.
*The display showing depends on choices made in parameter 0-02 and 0-03. The default setting
of parameters 0-02 and 0-03 depends on which region of the world the adjustable frequency drive
is supplied to, but it can be re-programmed as required.
No Operation
If
enable start.
Coast Inverse
If
cessary to enable start.
Select
•
•
Select
graphs.
Only display parameters selected in par. 0-20 and par. 0-24 can be viewed. It is possible to store
up to 120 samples in the memory for later reference.
Press [Quick Set-up] for selecting basic motor settings, ramp times, etc.
Press [Function Set-ups] for setting up the required functionality of the adjustable fre-
quency drive - if not already covered by the settings in [Quick Set-up].
General Settings
Choose between
My Personal Menu
to display only the parameters that have been pre-selected and pro-
is selected in terminal 27, no connection to +24 V on terminal 27 is necessary to
(factory default value) is selected in Terminal 27, a connection to +24 V is ne-
Changes made
to get information about:
the last 10 changes. Use the up/down navigation keys to scroll between the last 10
changed parameters.
the changes made since default setting.
Loggings
to get information about the display line readouts. The information is shown in
®
MG.20.M2.03 - VLT ist ein eingetragenes Warenzeichen von Danfoss.
Open-loop Settings Closed-loop Settings
, and
Par. Designation
0-01 Language
1-20 Motor Power
1-22 Motor Voltage
1-23 Motor Frequency
1-24 Motor Current
1-25 Motor Nominal Speed
3-41 Ramp 1 Ramp-up Time
3-42 Ramp 1 Ramp-down Time [s]
4-11 Motor Speed Low Limit
4-13 Motor Speed Low High
1-29 Automatic Motor Adaptati-
on
Tabelle 9.1: Quick Set-up parameters
9. Elektrische Daten
.
My Personal
[Units]
[kW]
[V]
[Hz]
[A]
[RPM]
[s]
[RPM]
[RPM]
[AMA]
127
9