Mounting The Round Connectors - Magnescale SR138-015R Anleitung

<9> Mounting the round connectors
Secure the connected male and female round connectors with the
accessory clamp.
Be sure to secure the connectors, as they are dangerous if loose.
1 Fit the connectors into the open side of the clamp.
2 Tighten the top and bottom edges of the clamp together
using the two accessory screws (+B M4×10).
3 Tighten the screws firmly until the top and bottom edges of
the clamp touch.
Then check that the connectors are secured firmly.
Clamp mounting dimensions and outer dimensions
The height dimension after mounting should be the same as the
outer diameter of the connectors.
22 (E)
30/1.17"
54/2.11"
Clamp
Tighten with binding pan
head screws (+B M4×10).
Tighten until the
edges touch.
Fig. 3-20