Installation; Technical Data - Abus EYSEO TV7300 Installationsanleitung

10. Installation

Proceed as follows when installing the camera.
1. Select a suitable place to mount the camera.
Without a protective housing, this camera must only be used in VdS-regulated conditions
out of arm's reach (min. 3m installation height).
2. Connect the video cable (recommended cable type: RG59) with the BNC video output of
the camera and the device directly connected to the camera. The maximum cable length
must not exceed 200 m.
3. Connect a power supply to the camera.
4. Hold the camera at the location where you want to mount it. Check the orientation and
angle of the camera.
5. Select the required settings in the camera's programming menu.
6. Set the required zoom range.
7. Fasten the camera. Make sure that the camera when outdoors has sufficient protection
(e.g., heated, weatherproof housing).
8. After completing your settings, push the protective cover over the keypad and seal the
position with the sticker supplied. (Note: The sticker can only be used once.)
Threaded hole
Fixing
screw
Use cable clips to ensure sufficient
pull relief of connection cables.

11. Technical data

Model number
CCD element
Number of pixels
TV lines
AGC range
Frame integration
Dynamic Range
Gamma correction
Light sensitivity
Signal-to-noise ratio
Electronic shutter control
E-ZOOM
With Balance
Video OUT
Power source
Power consumption 4.2W (DC) / 4.5 W (AC)
Video norm
Lens holder
Dimensions / Weight
Ambient operating
temperature
Ambient operating humidity
Lens holder
VdS cert.: VdS certification no. requested VdS certification no.: requested
Environment class
47
TV7300 TV7301
1/3" Interline transfer Super HAD CCD
PAL: 795 (H) x 596 (V), NTSC: 811(H) x 508(V)
500 TV lines (colour) 530 TV lines (B/W)
0-36dB
2x~160x
52dB
0.45 – 1
0.5 lux @ 30 IRE F1.2 / AGC 36dB ( colour)
50 dB
1/50s – 1 / 100,000s
1~4
ATW / PRSET/ MANUAL / PTL
2 x 1Vp-p / 75 Ohm / BNC plug connector
12VDC or 24VAC 100~ 240V AC
4.5 W (AC)
PAL / NTSC
1/3" C or CS mounting
H: 52 x W: 71 x D: 127,7 mm / 535 g
-10 °C – +50 °C
max. 90 % non-condensed
C/CS holder
II