Pioneer PDP-50MXE1 Bedienungsanleitung Seite 27

2 Using the 5/∞/2/3 buttons, move the screen to
the desired part of the image.
x 1.5
R12
24
SCROLL
÷ Pressing the POINT ZOOM and 5/∞/2/3 buttons
again will change the zoom ratio and the position of
screen enlarged.
÷ If the input signal changes, or if the menu screen is
displayed and the input is changed, or if the
multiscreen mode is selected, the POINT ZOOM
function will be canceled.
Multiscreen display
The plasma display's multiscreen function allows the
simultaneous display of two inputs. The multiscreen
display include three modes, 2-SCREEN, PinP, and PoutP.
SPLIT
SUB INPUT
1
Press the remote control unit's SPLIT button.
Each time the button is pressed the multiscreen
display changes in the following order:
3 2-SCREEN 3 PinP
P.ZOOM ZOOM
DISPLAY
PIP SHIFT
SWAP
3 PoutP 3 OFF
1 2-SCREEN
The main screen is displayed on the left and the
subscreen on the right.
2 PinP
The subscreen is displayed in one of the four corners
of the main screen.
3 PoutP
The subscreen is displayed outside the right side of
the main screen.
2
Press the remote control unit's SUB INPUT button
to select the subscreen input source.
To exchange the main screen and subscreen
inputs
Press the remote control unit's SWAP button.
¶ When 2-SCREEN mode has been selected:
The right and left sides of the display will switch; what
was previously the main screen will now show the
subscreen, and vice versa.
¶ When PinP or PoutP has been selected:
What was previously the main screen image will now
appear in reduced size as the subscreen image, and
vice versa.
Operation
66.0
R12
24
66.0
24 R12
66.0
R12
24
23
En