Herunterladen Inhalt Inhalt Diese Seite drucken

O Hardness; Delta Temp; Change Password - LAVAZZA EP 2500 PLUS Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 57
• Do not drink or risk causing the descaling
solution to be drunk.
• Danger of scalding, the descaling solu-
tion is dispensed at high temperature.
4
The machine will dispense the amount of solu-
tion provided. To increase the effectiveness
of the descaling product, the machine auto-
matically pauses for about 1 minute. During
the pauses, the display will show the mes-
sage "CHECK DRAWER-AUTOM. RESTART" and,
if necessary, the container used to collect the
solution can be emptied. However, it is possi-
ble to temporarily pause the cycle by pressing
"Enter", in order to allow emptying and dispos-
ing of the contents of the container. In this case,
press "Enter" to reactivate the cycle.
In case of interruption to the electrical supply dur-
ing the descaling cycle, upon being restarted again
the machine will automatically reposition itself in
the start position once more.
5
When the tank is emptied, the display will show
the message:
Alternated with the message:
6
So proceed to carefully wash and rinse the tank
with fresh drinking water.
Then refill it with non-carbonated, fresh drink-
ing water.
The display will show the message:
7
Position as large a container as possible under
the nozzle.
8
Press "Enter" to start rinsing the machine's hy-
draulic circuit, the display will show the mes-
sage:
WASHING CYCLE
IN PROGRESS
SETTINGS MENU
RINSE
TANK
FILL
TANK
START
RINSE
9
The machine will dispense the correct volume
of water. It is however possible to momentarily
interrupt the cycle, by pressing "Enter", to allow
the contents of the container used to collect
the water to be emptied and disposed of.
10
Reposition the empty container under the noz-
zle.
11
Push "Enter" to restart the cycle.
12
The machine may require the tank to be refilled
if the required volume of water has not been
reached. The message in this case is the one in-
dicated for point 6. Start again from point 8 to
complete the cycle.
13
When the machine has dispensed the required
volume of water, the following message is dis-
played:
DESCALING
It is then possible to dispense beverages once
again, topping up the tank if necessary with non-
carbonated, fresh drinking water.
H

O HARDNESS

2
By confirming "H
O Hardness" with "Enter" it is pos-
2
sible to input the data for the typical water hard-
ness of the location where the machine is installed.
This value can be measured with the special colour
changing strips available on the market. A value in
a range between 5 and 50 French degrees can be
input with buttons 4 and 5. This value is set by de-
fault to 20 French degrees. If a water softener filter is
used, set a water hardness value based on the hard-
ness abatement capability of the filter.

DELTA TEMP

By confirming "Delta Temp" with "Enter", it is pos-
sible to change the working temperature of the
boiler so as to slightly increase or reduce the tem-
perature of the dispensed product. The value can
be increased or reduced by a range of ±4 °C using
buttons 4 and 5.

CHANGE PASSWORD

By confirming the "Change Password" item with
"Enter" the display will show:
PASSWORD
FINISHED
E N
27

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis