Setting / Adjustment; Charging The Rechargeable Battery - Mafell MT55 18M bl Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für MT55 18M bl:

Inhaltsverzeichnis

Verfügbare Sprachen

to climb out of the kerf and jump back toward the

operator.

Kickback is the result of saw misuse and/or incorrect

operating procedures or conditions and can be

avoided by taking proper precautions as given below.

- Maintain a firm grip with both hands on the saw

and position your arms to resist kickback

forces. Position your body to either side of the

blade, but not in line with the blade. Kickback

could cause the saw to jump backwards, but

kickback forces can be controlled by the operator,

if proper precautions are taken.

- When blade is binding, or when interrupting a

cut for any reason, release the trigger and hold

the saw motionless in the material until the

blade comes to a complete stop. Never attempt

to remove the saw from the work or pull the

saw backward while the blade is in motion or

kickback may occur. Investigate and take

corrective actions to eliminate the cause of blade

binding.

- When restarting a saw in the workpiece, centre

the saw blade in the kerf so that the saw teeth

are not engaged into the material. If a saw blade

binds, it may walk up or kickback from the

workpiece as the saw is restarted.

- Support large panels to minimise the risk of

blade pinching and kickback. Large panels tend

to sag under their own weight. Supports must be

placed under the panel on both sides, near the line

of cut and near the edge of the panel.

- Do not use dull or damaged blades.

Unsharpened or improperly set blades produce

narrow kerf causing excessive friction, blade

binding and kickback.

- Blade depth and bevel adjusting locking levers

must be tight and secure before making the

cut. If blade adjustment shifts while cutting, it may

cause binding and kickback..

- Use extra caution when sawing into existing

walls or other blind areas. The protruding blade

may cut objects that can cause kickback.

Guard function

- Check the guard for proper closing before each

use. Do not operate the saw if the guard does

not move freely and enclose the blade

instantly. Never clamp or tie the guard so that

the blade is exposed. If the saw is accidentally

dropped, the guard may be bent. Check to make

sure that the guard moves freely and does not

touch the blade or any other part, in all angles and

depths of cut.

- Check the operation and condition of the guard

return spring. If the guard and the spring are

not operating properly, they must be serviced

before use. The guard may operate sluggishly due

to damaged parts, gummy deposits, or a build-up

of debris.

- Assure that the base plate of the saw will not

shift while performing a "plunge cut". Blade

shifting sideways will cause binding and likely kick

back.

- Always observe that the lower guard is

covering the blade before placing the saw

down on bench or floor. An unprotected,

coasting blade will cause the saw to walk

backwards, cutting whatever is in its path. Be

aware of the time it takes for the blade to stop after

switch is released.

Instructions on service and maintenance:

- Regularly cleaning the machine, especially the

adjusting devices and guides, constitutes an

important safety factor.

- Only original MAFELL spare parts and accessories

may be used. Otherwise the manufacturer will not

accept any warranty claims and cannot be held

liable.