Intended Use - Becker Centronic VarioControl VC260 Montage- Und Betriebsanleitung

The VC260 must only be used to control roller shutter systems with
fixed stops in the upper limit position and anti-lifting devices fitted.
The VC260 is only compatible with the P6/20G1 tubular drive. The
connection of external devices must be carried out in consultation
with specialist retailers.
▪ Please note that radio-controlled systems may not be used in
areas with a high risk of interference (e.g., hospitals, airports).
▪ The remote control is intended solely for use with equipment and
systems in which malfunctions in the hand-held transmitter or re‐
ceiver would not pose any risk to persons, animals or property, or
which contain safety devices to eliminate such risks.
▪ The operator is not protected from interference from other tele‐
communications systems and terminal equipment (e.g., even from
radio-controlled systems which are properly operated in the same
frequency range).
▪ Only connect radio receivers to devices and systems approved by
the manufacturer.
Note
Ensure that the control unit is not installed or op‐
▪
erated close to metal surfaces or magnetic
fields.
Radio-controlled systems transmitting on the
▪
same frequency may cause reception interfer‐
ence.
Note that the range of the radio signal is limited
▪
by legislation as well as by design.

Intended use

23